19 Publications
2016
Durability of Low Melt Alloys as Thermal Interface Materials
Roy, Chandan K⋅Roy, Chandan K⋅Roy, Chandan K⋅Roy, Chandan K⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Wayne Johnson, R⋅Wayne Johnson, R⋅Wayne Johnson, R⋅Wayne Johnson, R⋅Knight, Roy W⋅Knight, Roy W⋅Knight, Roy W⋅Knight, Roy W⋅Harris, Daniel K⋅Harris, Daniel K⋅Harris, Daniel K and Harris, Daniel K
Journal of Electronic Packaging, vol. 138, (no. 1), pp. 010913-7, 2016-03-01. | Journal Article
2015
Accelerated aging and thermal cycling of low melting temperature alloys as wet thermal interface materials
Roy, Chandan K⋅Roy, Chandan K⋅Roy, Chandan K⋅Roy, Chandan K⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Bhavnani, Sushil⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Hamilton, Michael C⋅Johnson, R. Wayne⋅Johnson, R. Wayne⋅Johnson, R. Wayne⋅Johnson, R. Wayne⋅Knight, Roy W⋅Knight, Roy W⋅Knight, Roy W⋅Knight, Roy W⋅Harris, Daniel K⋅Harris, Daniel K⋅Harris, Daniel K and Harris, Daniel K
Microelectronics Reliability, vol. 55, (no. 12), pp. 2704, December 2015. | Journal Article
 
Molecular scale analysis of dry sliding copper asperities
Vadgama, Bhavin⋅Vadgama, Bhavin⋅Vadgama, Bhavin⋅Jackson, Robert⋅Jackson, Robert⋅Jackson, Robert⋅Harris, Daniel⋅Harris, Daniel and Harris, Daniel
Applied Nanoscience, vol. 5, (no. 4), pp. 480, 20150400. | Journal Article
2013
Effective thermal conductivity and junction factor for sintered microfibrous materials
Sheng, Min⋅Sheng, Min⋅Cahela, Donald R⋅Cahela, Donald R.⋅Yang, Hongyun⋅Yang, Hongyun⋅Gonzalez, Carlos F⋅Gonzalez, Carlos F.⋅Yantz, William R⋅Yantz, William R.⋅Harris, Daniel K⋅Harris, Daniel K.⋅Tatarchuk, Bruce J and Tatarchuk, Bruce J.
International Journal of Heat and Mass Transfer, vol. 56, (no. 1-2), pp. 10-19, 2013. | Journal Article
2007
Measurements of the contact angle between R134a and both aluminum and copper surfaces
Vadgama, Bhavin and Harris, Daniel K
Experimental Thermal and Fluid Science, vol. 31, (no. 8), pp. 979-984, 2007. | Journal Article
2006
A device and technique to measure the heat transfer limit of a planar heat pipe wick
Williams, Richard R and Harris, Daniel K
Experimental Thermal and Fluid Science, vol. 30, (no. 3), pp. 284, 2006. | Journal Article
2005
The heat transfer limit of step-graded metal felt heat pipe wicks
Williams, Richard R and Harris, Daniel K
International Journal of Heat and Mass Transfer, vol. 48, (no. 2), pp. 293-305, 2005. | Journal Article
2003
Cross-plane and in-plane porous properties measurements of thin metal felts: applications in heat pipes.
Williams, R. R and Harris, Daniel K
Experimental Thermal and Fluid Science, vol. 27, (no. 3), pp. 227-235, 2003. | Journal Article
 
Radiating fin analysis using an extended perturbation series solution technique.
Harris, Daniel K and Simionescu, F.
Journal of Spacecraft and Rockets, vol. 40, (no. 1), pp. 141-142, 2003. | Journal Article
2002
A computational study on solder bump geometry, normal, restoring, and fillet forces during solder reflow in the presence of liquefied underfill
Zhang, Yun⋅Zhao, Renzhe⋅Harris, Daniel K and Johnson, Wayne
IEEE Transactions on Electronics Packaging Manufacturing, vol. 25, (no. 4), pp. 308-317, 2002. | Journal Article
 
Measurements of the overall heat transfer from combustion gases confined within elliptical tube heat exchangers
Harris, Daniel K⋅Harris, Daniel K.⋅Goldschmidt, Victor W and Goldschmidt, Victor W.
Experimental Thermal and Fluid Science, vol. 26, (no. 1), pp. 33-37, 2002. | Journal Article
2001
Wet layup and sintering of metal-containing microfibrous composites for chemical processing opportunities
Harris, Daniel K⋅Harris, D. K.⋅Cahela, D. R⋅Cahela, D. R.⋅Tatarchuk, B. J. and Tatarchuk, Bruce J
Composites Part A: Applied Science and Manufacturing (UK), vol. 32A, (no. 8), pp. 1117-1126, 2001. | Journal Article
2000
Empirically derived predicators of natural gas flame lengths in circular tubes
Harris, Daniel K⋅Warren, Donald⋅Raleigh, William F and Goldschmidt, Victor W
ASHRAE TRANS, vol. 106 (PA, pp. 341, 2000. | Journal Article
 
Heat transfer of a U-bend in a cross flow of air at different angles of incidence
Fang, Lei⋅Fang, Lei⋅Harris, Daniel K.⋅Harris, Daniel K⋅Goldschmidt, Victor W and Goldschmidt, Victor W.
International Journal of Heat and Mass Transfer, vol. 43, (no. 17), pp. 3053-3059, 2000. | Journal Article
1999
Coolness
Harris, Daniel
The American Scholar, vol. 68, (no. 4), pp. 39-49, Autumn 1999. | Journal Article
 
Empirical investigation into the external heat transfer of a U-bend in cross-flow
Harris, Daniel K and Goldschmidt, VW
INT J HEAT MASS TRANSFER, vol. 42, (no. 11), pp. 1957-1968, 1999. | Journal Article
 
Empirically derived predicators of natural gas flame lengths in circular tubes
Harris, Daniel K.⋅Harris, Daniel K⋅Raleigh, William F⋅Warren, Donald⋅Raleigh, William F.⋅Warren, Donald⋅Goldschmidt, Victor W. and Goldschmidt, Victor W
HVAC&R Research, vol. 5, (no. 2), pp. 139, Apr 1999. | Journal Article
1997
Heat transfer processes of serpentine tubular heat exchangers (Dissertation)
Harris, Daniel K (1997).
1996
Impact of manifold design on heat exchanger efficiency
Harris, Daniel K⋅Goldschmidt, Victor W and Warren, Donald G
IECEC 96; Proceedings of the 31st Intersociety Energy Conversion Engineering Conference, Washington, DC; UNITED STATES; 11-16 Aug. 1996. 1996. | Conference Proceeding